Model:UHF RFID BYPLUS
This HF RFID Access Reader can be applied for access control. It is possible through WiFi to read HF Tags or Access controlling. RS-485 communication interface. The backstage supports to read HF Tags to read, write, authorize, format, and so on. It also can connect to one more set of HF RFID Access Reader for sparing. When HF RFID Access Reader is malfunction and the spare HF RFID Access Reader will take over. Then the Access System can work continuously again. When Tags are close to HF RFID Access Reader, PC will emit “dee” prompt which represent it is transmitting data. After reading and writing, if HF Tag are still within in sensing area, the HF RFID Access Reader will not give any tips or send data. However, when exceeding time interval or any different HF Tags enter sensing area respectively, HF RFID Access Reader will be continuously reading HF Tags and output data. HF RFID Access Reader has high RFID protocol compatibility, small size, fast read rate, multi-label reading, etc. It can be widely used on vary RFID systems.
Working Frequency: 13.56MHz
Communication: Standard HID communication
Working Voltage: 6~28V
Reading Distance: 5CM
Wireless access control reader via WiFi
Expand and control peripheral devices via WiFi interworking RS-485, or control HF RFID Access Reader.
Built-in WiFi signal strength indicator.
Memory more than 100 sets of Tag numbers, offline identification Tag number.
Through the AT command, you can control without writing software separately.
ARM32 bit high-end design, computer control, high-speed response.
Enables to connect with WENSHING smart material box to read MPS number.
Environment: temperature 0~50℃, air pressure 88~106Kpa
Storage Temperature: -10~+80℃
Working Temperature: 50~95% (no condensation)
Wireless Access Management
RFID Reading/Writing card device
AGV reading ground Tag